Curtis 3000 Specifications download pdf (Page 19)

Figure 13. Lift Frame Mounting Reference View

Torsion Spring Bushing

1/2" Patch Bolt

A-Frame Spring Stop

Left Side Shown

5/8" Locknuts installed

on Outside of Lift Frame

Spring Keeper on Side Plate

Torsion Spring

Lift Frame

Side Plate

Section 7. Lift Frame Setup

A.) Mount Lift Arm (1TBP40) to Upper Mounting Tabs of Lift Frame as shown in Figure 14A. Lift Arm

mounts with (1) 3/4" x 4-1/2" Clevis Pin (1TBP42) and is secured with a 2" Cotter Pin.

B.) Locate Lift Cylinder (1TBP44A) and mount to front of Lift Arm with 1" Piston Spacers (1TBP109).

The 1" x 4-1/2" Clevis Pin (1TBP108) will pass through the Piston Spacers and Lift Cylinder and will be

secured with a 2" Cotter Pin. Figure 14A.

The Hose Port on the Lift Cylinder must face towards the Driver’s Side.

 C.) With top of Lift Cylinder secured, raise the Lift Arm and swing the Lift Cylinder bottom between

Lower Mounting Tabs on the Lift Frame and secure with a 3/4" x 2-3/4" Clevis Pin (1TBP43) and a

2" Cotter Pin. Figure 14B.

D.) The Hydraulic Hose should now be connected to the 45º Elbow. Use (2) 9/16" wrenches when tightening

Lift Hose to avoid twisting the Hose.

E.) Mount Lights to Lift Frame using supplied hardware (1TBP161) and Harness Plug Holder (1TBP135).

See Figure 15.

NOTE

Sno-Pro 3000 Assembly Instructions

19 of 29

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 28 29

No comments

Curtis 3000 Specifications Page 19