Curtis PLCD3717A User Manual download pdf (Page 14)

WALL MOUNT INSTALLATION

INSTALLING REMOVING THE BASE STAND

WARNING

: The TV Display is very fragile and must be protected a t all times when removing the b ase

Stand

Be sure that no hard or sharp object or anything that could scratch or damage the TV display comes into

contact with it Do NOT exert pressure on the front of the unit at any time because the screen could crack

1 Disconnect all cables or cords connected to the unit

2 Lay the unit down on a flat surface with the back side facing up Please make sure to place a soft

cushioned material such as a pillow or thick piece of foam beneath the screen

3 To remove the base stand loosen screws off the holes then pull downwards to release

the base stand

. .

. ,

MOUNTING ON THE WALL

NOTE

Remove the base stand before mounting the unit on the wall.

This unit is VESA-compliant, and is designed to be wall-mounted with a VESA-compliant 12”x 17”

(300mm x 430mm) mounting kit designed for flat-panel TV's (not supplied). Mount this unit according to

the instructions included in the mounting kit.

Length of screw should not exceed 12 mm.

12”

17”

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 72 73

No comments

Curtis PLCD3717A User Manual Page 14