1
Symbols
WARNINGS – To help avoid personal injury
Important Notes/Cautions – from the factory
Sanitation Requirements
Models Included:
WARNING HOT LIQUID,
Scalding may occur.
Avoid splashing.
The Curtis G3 Brewer is Factory Pre-Set and Ready to Go… Right from the Box.
Following are the Factory Settings for the G3 Iced Tea Brewer.
Generally there will never be a reason to change the G3/Gold Cup Series default settings. However, should you need to make slight
adjustments to meet your brewing needs, programming instructions are provided later in this manual.
System Requirements:
SETUP STEPS
the brewer.
caused by an empty tank.
readout.
5. Important: Run one full brewcycle, to purge the water lines and valves of air. Five seconds of dilution water at the beginning of each
brewcycle is normal pre-programmed operating behavior.
NSF International requires the following water connection:
cleaning underneath.
installed and maintained in accordance with federal, state, and local codes.
BREWING INSTRUCTIONS
Pour leaf tea into basket.
3. Slide brew cone into brew
rails. Place tea container
under brew cone.
brew tea.
IMPORTANT:
After setup, run a FULL
brewcycle. Place a tea
container to catch both hot water
from the brewcone and dilution water
from spout on the front cover.
Wilbur Curtis Company, inC.
Service Manual – TCT & PTT
Important Safeguards/Symbols
This appliance is designed for commercial use. Any servicing other than cleaning and preventive maintenance should be performed by an
ISO 9001:2008 REGISTERED
WILBUR CURTIS CO.
Montebello, CA 90640
For the latest information go to
www.wilburcurtis.com
Tel: 800/421-6150
CAUTION: DO NOT
connect the unit to hot
water. The inlet valve is
not rated for hot water.
CAUTION: Follow this
setup procedure before
attempting to use this
unit. Failure to follow these instruc-
tions can result in injury and/or void
of warranty.
CAUTION:
must be installed to
comply with applicable
federal, state, and local plumbing/
electrical codes having jurisdiction.
Comments to this Manuals